Термореактивная машина для литья под давлением с термообработкой 90BBE до 400BBE

ДОПОЛНИТЕЛЬНЫЕ ЭЛЕМЕНТЫ ДЛЯ ОБРАБОТКИ ТЕРМОСЕТОВ

• На неподвижные и подвижные плиты устанавливаются стальные и стеклопластиковые плиты для изоляции тепловыделения от термореактивной формы.
• Специальная конструкция, позволяющая выпускать газы внутри формы в два этапа.
• Температуры стержня и полости пресс-формы являются цифровыми и устанавливаются индивидуально.

SPECIAL SCREW BARREL DESIGN FOR THERMOSET MOLDING

• Barrel sleeve is nitrified, and the screw is thermally sprayed to strengthen wear resistance and lifespan. 
• One-piece rod, less L/D ratio, and compression-free screw design make melt flow smoothly. 
• A linear transducer calculates the injection and plasticizing strokes and displays the correct and precise position. 
• The single-carriage cylinder at the rear side provides easy access to disassemble the barrel or nozzle and to save space on the purging area.

SPECIAL SCREW BARREL DESIGN FOR THERMOSET MOLDING

• Barrel sleeve is nitrified, and the screw is thermally sprayed to strengthen wear resistance and lifespan. 
• One-piece rod, less L/D ratio, and compression-free screw design make melt flow smoothly. 
• A linear transducer calculates the injection and plasticizing strokes and displays the correct and precise position. 
• The single-carriage cylinder at the rear side provides easy access to disassemble the barrel or nozzle and to save space on the purging area.

THREE-STAGES HEATING COMPONENT FOR KEEPING THERMOSETS UNDER A PERFECT PLASTISIZING CONDITION

• A specific three-stages heating component (oil heater, electric heater, and cooling loop) used to maintain a stable barrel temperature and to ensure a good melt status of the thermoset material inside of the barrel. 
• The oil heater commissioning at the front of the barrel sleeve reaches an optimum temperature range to improve the repeatability of the quality of the article.